Top 9 Notes for CNC Pipe Cutting Machine

Top 9 Notes for CNC Pipe Cutting Machine

Cnc-Pipe-Cutting-Machine

There are top 9 notes for CNC pipe cutting machine. And I will share with you today.

1) When move the workbench or spindle, you should select the correct moving speed according to the distance between the workpiece, so as to prevent collisions when moving too fast.

2) To determine the correct processing technology and processing route according to the actual situation when programming, preventing the workpiece scrapped or cut off in advance led by insufficient processing position or not enough take edge strength.

3) Procedures and the compensation amount must be confirmed to be correct before the pipe cutting.

4) Check whether the electrode wire tension is adequate. In taper cutting, the tension should be adjusted down to half of the usual tone.

5) Check if the electrode wire feeding speed is appropriate.

6) Choose the open processing or adhesion processing according to the actual situation of the parts to be machined, try to shorten the distance between the nozzle and the workpiece on the premise of avoiding interference. While adhesion processing, the general distance between the nozzle and the workpiece should be 0.05 ~ 0.1mm.

7) Check whether the jet stream selection is reasonable, a high pressure jet when roughing while finishing with a low pressure jet.

8) Cautiously observe the processing stability when it begins to cut, adjust in time when adverse found.

9) During the processing, should often inspect and supervise the cutting condition, solve the problems immediately when found.

Want to learn more information about CNC pipe cutting machine, please visit www.arcbro.com.

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注

此站点使用Akismet来减少垃圾评论。了解我们如何处理您的评论数据